Speed controller & Co.

Function: The new electronic level differential switch WPS3000plus is suitable for automatic level monitoring of conductive liquids in containers, wells, water tanks and the like. The device can be configured either as a refilling device or as an emptying device by means of a slide switch on the front. In this case, the liquid level is automatically maintained between two water sensors (min. and max.). When water enters or reaches a certain level, a relay picks up and switches e.g. mains-operated pumps, valves or warning devices on or off. The WPS 3000plus is suitable for all storage tanks made of concrete, plastic or metal and is quickly installed as all connections are plug-in. Due to the omission of moving float switches, it operates absolutely interference-free. Features: - Switching point freely selectable at any water level via two water sensors- For all storage tanks made of concrete, plastic or metal- Switching output (rel.) configurable as NC or NO (fill/empty) via switch on the front- Remote measurement possible up to 25 m via two-wire cable- Special features: The measuring electrodes are chlorine and salt water resistant (stainless steel AISI 316 / V4A)- No dangerous mains voltage at the water sensor- Operation and monitoring-free- Very simple and quick installation, as ready to plug in- LED displays for mains, sensor min, sensor max, error and rel. on

The speed controller reduces the power output of pumps (up to 350 W power consumption) via their speed. It works with a so-called phase angle control; suitable for asynchronous motors.

Mit dem ODR-300 können Asynchron-Wechselstrommotoren stufenlos in Drehzahl und damit Stromverbrauch angesteuert werden. Die meisten Teichpumpen werden z.B. von Asynchron-Spaltpolmotoren angetrieben. Der ODR-300 regelt die Spannung am Stromausgang im Bereich von 100 bis 230 V~ bei gleichbleibender Frequenz (50/60 Hz). Der ODR-300 darf NICHT für die Pumpenserie „OSAGA Grüne Minna“ verwendet werden. Er ist NICHT für die Regelung von Belüftungskompressoren geeignet, ebenso NICHT für Geräte, die ein Vorschaltgerät oder Netzteil haben.

Glass fibre reinforced polyamide housing, NBR rubber diaphragm, stainless steel core and screws. Pre-pressure 0.4 bar, working pressure 0.4 to 10 bar at 20°C, maximum working temperature + 4°C - + 75°C. Can be mounted in all positions. Working current 2.2 watts, current consumption 185 mA, closed as standard. Coil with bayonet lock and manual operation. All taps are tested!

Cable temperature sensor Temperature sensor - suitable for TS 1000. You need this temperature sensor as an accessory or spare part for the TS 1000.   

Function: The TS 1000 temperature controller is ideally suited for all areas of application where temperature control is required in heating or cooling mode. An external temperature sensor records measuring ranges from -99 to +850°C. Features: - For wall mounting- PT1000 temperature sensor (not included)- Switching temperature freely adjustable from -99 ... +850 °C- Min./max. display- Serial interface for reading out measured data (optional)- Operation and monitoring free- Sensor short-circuit and sensor interruption are detected immediately- Output switches off in the event of a sensor error- Adjustable to heating or cooling- LED indicators for relay on, heating (red), cooling (yellow)- Data retention in case of power failure

Single transformer of 220 volts, output: 26 VAC, 600 mA and 15.6 VA. Fits all common irrigation computers.