Action pull gate 75 mm
Abbildung ähnlich
23,95 EUR*
Dostupno, vrijeme dostave 2-3 Tage (5-7 Tage bei Versand ins Ausland)
Broj proizvoda:
604147
PVC fittings come from industrial plant construction and are characterised by their high pressure resistance (up to 16 bar). Pipe systems made with this system are also very durable and cost-effective.
PVC fittings come from industrial plant construction and are characterised by their high pressure resistance (up to 16 bar). Pipe systems made with this system are also very durable and cost-effective. Fittings with a maximum pressure resistance of 10 bar are usually sufficient for ponds. Before you glue the pipes, however, you should observe the following instructions:
sand the
bonding surfaces of the pipe parts to be joined with fine sandpaper.
then clean the bonding points with our PVC cleaner to remove dust and grease.
apply the adhesive to the bonding point and allow it to flash off briefly
.
Put the parts together and turn them a little.
after about 8 seconds, it is no longer possible to change the connection!
observe the specified drying time of the adhesive before pressurising the pipe and allowing water to reach the gluing points
.Always carry out all work only in well-ventilated rooms and seal the adhesive and cleaner immediately after use! Make sure that adhesive and cleaner do not get on textiles, as adhesive is almost impossible to remove and cleaner can cause discolouration.
| Article type: | Draw slide |
|---|---|
| Material: | PVC |
| Size: | 90 mm, 160 mm, 63 mm , 75 mm, 50 mm |